|
Measures reported by HPStOReplicaTest
HP StoreOnce Data Replication Solution Service helps you configure the best possible performance of your replication environment. Replication data services include replication mapping for Virtual Tape Libraries and NAS shares, and general replication settings. Replication mapping is available for source and target Virtual Tape Libraries and NAS shares. If the Data Replication Service is faulty /stopped/not running, then, data replication may be indefinitely halted until the service is restored. If the replication is halted more frequently, then, the data stored in the Virtual Tape Libraries and the NAS Shares may not be in sync with the source leading to data inconsisitencies. To avoid such inconsistencies, it is essential to monitor the status of the replication service at all times. The HPStOReplicaTest helps administrators in this regard!
This test reports the overall status and health of the HPE StoreOnce Data Replication Service. Besides, administrators can also figure the level of activity on the replication service.
Outputs of the test : One set of results for the target HPE StoreOnce Backup system being monitored.
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| repStatus |
Indicates the current status of the replication service. |
|
The values that this measure can report and their corresponding numeric values are tabulated below:
| Measure Value |
Numeric Value |
| Fault |
0 |
| Not started |
1 |
| Stopped |
2 |
| Not running |
3 |
| Initialising |
4 |
| FailedToInitialise |
5 |
| Shutting down |
6 |
| Suspended |
7 |
| Terminating |
8 |
| FailedToTerminate |
9 |
| Removing Drives |
10 |
Note:
| By default, this measure reports the above-mentioned Measure Values only. However, in the graph of this measure, the status will be represented using the corresponding numeric equivalents only.
| repHealthLevel |
Indicates the overall health of the replication service. |
|
The values that this measure can report and the states they indicate are tabulated below:
| Measure Value |
Numeric Value |
| Unknown |
0 |
| Ok |
1 |
| Information |
2 |
| Warning |
3 |
| Critical |
4 |
Note:
By default, this measure reports the above-mentioned Measure Values while indicating the overall health of the replication service. However, the graph of this measure will be represented using the corresponding numeric equivalents of the measure values as mentioned in the table above. |
| receiveBandwidth |
Indicates the rate at which data was received by the replication service during the last measurement period. |
MB/Sec |
A sudden/gradual increase/decrease in the value of this measure signals a potential congestion or slowdown of data reception by the replication service. |
| transmitBandwidth |
Indicates the rate at which data was transmitted through the replication service during the last measurement period. |
MB/Sec |
A sudden/gradual increase/decrease in the value of this measure signals a potential congestion or slowdown of data transmission through the replication service. |
|