Measures reported by MkiWrUplinkStatTest
This test auto-discovers the uplink interfaces of the target Cisco Meraki and for each uplink interface, reports the current status. This test further reports whether static IP was used for the uplink interface or not.
Outputs of the test : One set of results for each Network:Access Point:Uplink interface combined to the target Cisco Meraki being monitored.
First-level descriptor: Network
Second-level descriptor: Access Point
third-level descriptor: Uplink interface
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| Device_status |
Indicates the current status of this uplink interface |
|
The values reported by this measure and its numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| Active |
1 |
| Down
| 0 |
Note:By default, this measure reports the Measure Values listed in the table above to indicate the current status of this uplink interface.The graph of this measure however, is represented using the numeric equivalents only i.e., 0 or 1.
|
| isStaticIP_used |
Indicates whether/not static IP was used for this uplink interface |
|
The values reported by this measure and its numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| No |
0 |
| Yes
| 1 |
Note:By default, this measure reports the Measure Valueslisted in the table above to indicate the current status of this uplink interface.The graph of this measure however, is represented using the numeric equivalents only i.e., 0 or 1.
|
|