Measures reported by FPRSPSTest
This test auto-discovers the powersupply units of the target Fujitsu Primergy Rack server and for each powersupply unit determines the current status and the output passing through each unit. This way, administrators can be proactively alerted to powersupply units that are about to fail and the units through which abnormal amount of output power is passing through.
Outputs of the test : One set of results for each Rack Unit: Powersupply unit available on the target Rack server being monitored.
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| psStatus |
Indicates the current state of this fan. |
|
The values reported by this measure and its numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| Power safe mode |
0 |
| Unknown |
1 |
| Not present |
2 |
| Ok |
3 |
| AC failed |
5 |
| DC failed |
6 |
| Critical temperature |
7 |
| Not manageable |
8 |
| Fan failure predicted |
9 |
Fan failure |
10 |
| Non redundant DC failed |
12 |
| Non redundant AC failed |
13 |
| Failed |
14 |
Note:
By default, this measure reports the Measure Values listed in the table above to indicate the current state of each powersupply unit. The graph of this measure however is represented using the numeric equivalents only. |
| psLoad |
Indicates the actual output power passing through this powersupply unit. |
Watts |
The value of this measure should be within admissible range. If the value of this measure increases/decreases suddenly, then it may damage the powersupply unit and this may in turn affect the performance of the hardware components of the target server. |
|