eG Monitoring
 

Measures reported by LHSysPwSupplyTest

Often, sudden failure of the power supplies of storage nodes can cause the storage system to crash, leading to critical loss of data. To avoid this, you need to keep an eye on the state of each power supply unit. This can be achieved using the LHSysPwSupplyTest test. This test auto-discovers the power supplies on the target storage system and reports the current state of each power supply. Using this test, power supplies that are running abnormally can be detected with ease.

Outputs of the test : One set of results for every storage node:power supply of the target storage system that is to be monitored.

The measures made by this test are as follows:

Measurement Description Measurement Unit Interpretation
Status Indicates the current status of this power supply.   The values reported by this measure and their corresponding numeric equivalents are mentioned in the table below:

Measure Value Numeric Value
Normal 1
Abnormal 2
Note:

This measure reports the Measure Values listed in the table above to indicate the current state of each power supply. However, in the graph of this measure, the state is indicated using the Numeric Values listed in the above table.