Measures reported by WAPVirtualAPStTest
Virtual Access Points (VAPs) simulate multiple access avenues in one physical WAP device; VAPs are similar to Ethernet VLANs. Each VAP can be enabled or disabled independently and is identified by a user - configured Service Set Identifier (SSID).
For each Virtaul Access Point configured on the target Cisco Wireless Accesspoin, this test reports the administrative status and operational status. By comparing the operational state across the VAPs, administrators can figure out the VAP that is not operational for a considerable time period.
Outputs of the test : One set of results for each virtual accesspoint on the target Cisco Wireless Accesspoint being monitored.
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| Administrative_status |
Indicates the current administrative status of this virtual accesspoint. |
|
The values reported by this measure and their corresponding numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| Up |
1 |
| Down |
0 |
Note:
By default, this measure reports the above-mentioned Measure values while indicating the administrative status of this virtual accesspoint. However, in the graph of this measure, states will be represented using their corresponding numeric equivalents - i.e., 0 or 1.
|
| Operational_status |
Indicates the current operational status of this virtual accesspoint. |
|
The values reported by this measure and their corresponding numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| Up |
1 |
| Down |
0 |
Note:
By default, this measure reports the above-mentioned Measure values while indicating the authentication status of each client. However, in the graph of this measure, states will be represented using their corresponding numeric equivalents - i.e., 0 or 1.
|
|