eG Monitoring
 

Measures reported by CisIpSlaOperTyTest

This test reports the current state of each operation type. In addition, this test reports the round trip time of each operation type, packet loss, average latency, count of delayed packets, and packets out of sequence.

Outputs of the test : One set of results for each type:operation combination on the Cisco device that is monitored.

Measurement Description Measurement Unit Interpretation
Operation_status Indicates the current state of this operation of this operation type.   The values that this measure can report and their corresponding numeric values have been described in the table below:

Measure Value Numeric Value
OK 1
Down 2,4,6 to 16
Critical 3
Unknown 5

Note:

By default, this measure reports one of the Measure Values listed in the table above to indicate the current state of this operation. The graph of this measure however, represents the same using the numeric equivalents mentioned in the table above.
Round_trip_time Indicates the time measured between the start of packet transmission from the source device to the start of receiving the acknowledgment from the destination device for this operation type.  Miilliseconds  
Avg_jitter_value Indicates the average variation of response time in receiving the acknowdgement from the destination device for this operation type. Miilliseconds  
Packet_loss Indicates the total number of packets that were lost during transmission from the source to destination while this operation of this operation type was performed. Number Ideally, the value of this measure should be zero.
Average_latency Indicates the average time taken to transmit the response from the destination to the source for this operation type. Milliseconds  
Mean_opinion_score Indicates the percentage of speech quality between the source and destination for this operation type. Percent  
Packets_late_arrival Indicates the total number of packets that were received by the destination with delayed arrival for this operation of the operation type. Number  
packets_out_of_sequence Indicates the number of packets that were not received in the same order as it was transmitted for this operation of this operation type. Number