Measures reported by ExcActSyncConTest
Exchange ActiveSync lets you synchronize a mobile device with your Exchange 2010 mailbox, so that you can check your emails from your mobile phone itself! Whenever a mobile phone user complaints that he/she is unable to check or is experiencing slowness when checking emails on his/her mobile phone, Exchange administrators need to quickly determine what is causing the non-sync - is it because ActiveSync is unable to synchronize with the user's mailbox? Or is it because ActiveSync is taking too long to perform the synchronization? At which stage of the synchronization did the failure/delay occur? This test helps answer all these questions.
The test periodically checks ActiveSync connectivity at every stage (a.k.a scenario) of the synchronization - eg., the Logon stage, the FolderSync stage, the Options stage, etc. - reports issues and latencies (if any) in connectivity, and leads you to the exact stage at which the failure/slowdown occurred.
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| Event_type |
Indicates whether the ActiveSync connectivity check was successful or not at this stage/scenario of the synchronization. |
|
If the value of this measure is Success, it indicates that the ActiveSync connectivity check was successful at this stage. If the value of this measure is Failure, it indicates that mailbox synchronization using ActiveSync failed at this stage. The numeric values that correspond to these measure values are as follows:
| Measure Value |
Numeric Value |
| Success |
1 |
| Failure |
0 |
Note:
Typically, this measure reports the Measure Values listed in the table above to indicate the ActiveSync connectivity status. However, in the graph of this measure, the Numeric values are used to represent the connectivity status. |
| Latency_time |
Indicates the time taken by ActiveSync to successfully complete this stage/scenario of the synchronization. |
Secs |
A low value is desired for this measure. A high value indicates that this stage/scenario of the synchronization is taking too long to complete.
Compare the value of this measure across stages/scenarios to know where the maximum delay occurred. This will greatly aid troubleshooting. |
|