|
Measures reported by HwAmperageTest
This test reports the current state, status, and reading for each amperage probe on a server. This test executes only on IBM/Dell servers.
The measures
made by this test are as
follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| State |
Indicates the current state of this amperage probe. |
|
The values this measure can report and their numeric equivalents are available in the table below:
| Measure Value |
Numeric Value |
| Enabled |
0 |
| Unknown |
1 |
| enabledAndNotReady |
3 |
| Not Ready |
5 |
Note:
This measure reports the Measure Values listed in the table above to indicate the current state of an amperage probe. However, in the graph of this measure, the probe state is indicated using only the Numeric Values listed in the above table. |
| Status |
Indicates the current status of this amperage probe. |
|
The values this measure can report and their numeric equivalents are available in the table below:
| Measure Value |
Numeric Value |
| Other |
1 |
| Unknown |
2 |
| Ok |
3 |
| Non Critical Upper |
4 |
| Non Critical Lower |
5 |
| Non Recoverable Upper |
6 |
| Critical Upper |
7 |
| Critical Lower |
8 |
| Non Recoverable Lower |
9 |
| Failed |
10 |
Note:
This measure reports the Measure Values listed in the table above to indicate the current status of an amperage probe. However, in the graph of this measure, the probe status is indicated using only the Numeric Values listed in the above table. |
| Amperage_probe_reading |
Indicates the current reading of an amperage probe of type other than amperageProbeTypeIsDiscrete. |
Amps |
|
|