Configuration of CorOSStatusTest

Whenever users complain that they are unable to access the containers and pods launched by the CRI-O container engine, you may want to know whether it is owing to a bad network connection or between the user terminal and the CRIO-O container engine or owing to abrupt failure of the CRIO service. Using this test, you can track the current status of the CRIO service and be promptly alerted when it is not loaded or inactive.

The default parameters associated with this test are:

• The TEST PERIOD list box helps the user to decide how often this test needs to be executed.

• In the HOST text box, specify the HOST for which this test is to be configured.

• In the PORT text box, specify the port at which the target host is listening. The default is 2379.

• By default, USE SUDO flag is set to No. This indicates that, by default, this test will report the metrics by executing the crictl command. However, in some highly secure environments, the eG agent installed user may not have the permissions to execute this command directly. In such cases, do the following:

  • Edit the SUDOERS file on the target host and append an entry of the following format to it:

    <eG_agent_install_user> ALL=(ALL) NOPASSWD:<Command>

    For instance, if the eG agent install user is eguser, then the entries in the sudoers file should be:

    eguser ALL=(ALL) NOPASSWD: crictl

  • Finally, save the file.

  • Then, when configuring the test using the eG admin interface, set this parameter to Yes. This will enable the eG agent to execute the sudo crictl command and retrieve the relevant metrics for this test.

• If multiple components of the same component type are awaiting configuration, then an APPLY TO OTHER COMPONENTS button will appear in this page. Clicking on this button will allow you to apply the configuration to all/selected components of that type.

• Once the necessary values have been provided, clicking on the UPDATE button will register the changes made.

When changing the configuration for specific servers, a “*” beside the text box corresponding to the parameter signifies that these values have to be manually configured by the user. The parameter values that require to be configured will typically be prefixed with a “$” or contain a series of “*”. A value of “none” in the parameter value indicates that the corresponding parameter value can be changed if required.