eG Monitoring
 

Measures reported by FPRSVoltTest

This test auto-discovers the voltage sensors on the target Fujitsu Primergy Rack server and for each sensor, this test reports the current status. Using this test, administrators can easily figure out the sensors that are out of range, the sensors on which high voltage is passing etc and rectify the discrepancies before the sensors fail.

Outputs of the test : One set of results for each Rack Unit: Voltage sensor available on the target Rack server being monitored.

The measures made by this test are as follows:

Measurement Description Measurement Unit Interpretation
voltStatus Indicates the current state of this temperature sensor.   The values reported by this measure and its numeric equivalents are mentioned in the table below:

Measure Value Numeric Value
Unknown 1
Not available 2
Ok 3
Too low 4
Too high 5
Out of range 6
Warning 7

Note:

By default, this measure reports the Measure Values listed in the table above to indicate the current state of each voltage sensor. The graph of this measure however is represented using the numeric equivalents only.