eG Monitoring
 

Measures reported by PANOPSerDetTest

The Egenera PAN Manager application runs on a PAN OPServer that is running on a 64-bit Red Hat. The PAN Manager application running on the PAN OPServers manages the physical and virtual resources of the domain(s) in the PAN. The Egenera PAN Manager is designed to run redundantly on two PAN OPServers, in a master/slave role. The master PAN OPServer performs all management functions while the slave has the ability to assume the master responsibilities in case of failure in the master PAN OPServer.

This test reports the status of the PAN OPServer hosting the PAN Manager application and helps the administrator to figure out if this PAN OPserver is the master in a redundant setup.

The measures made by this test are as follows:

Measurement Description Measurement Unit Interpretation
Status Indicates the current status of this PAN OPServer.   This measure reports a value Available if this PAN OPServer is currently available and a value Not Available if otherwise.

The numeric values that correspond to the above-mentioned measure values are as follows:

Measure Value Numeric Value
Not Available 0
Available 1

Note:

By default, this measure reports the above-mentioned Measure Values while indicating the status of this PAN OPServer. However, the graph of this measure will be represented using the corresponding numeric equivalents of the Measure Values as mentioned in the table above.

The detailed diagnosis capability of this measaure if enabled, lists out the global IP address, the name of the Network Interface through which the global IP is assigned, the IP address of the master PAN POServer, the name of the master PAN OPServer, the IP adress of the slave PAN OPServer, the name of the slave PAN OPServer, the version of the PAN OPServer and the role of this PAN OPServer in this Egenera PAN Manager.

Is_master Indicates whether/not this PAN OPServer is the master in a redundant setup.   This measure reports a value Yes if this PAN OPServer is the master in a redundant setup and a value No if this PAN OPServer is not the master.

The numeric values that correspond to the above-mentioned measure values are as follows:

Measure Value Numeric Value
No 0
Yes 1

Note:

By default, this measure reports the above-mentioned Measure Values while indicating whether/not this PAN OPServer is the master. However, the graph of this measure will be represented using the corresponding numeric equivalents of the Measure Values as mentioned in the table above.