eG Monitoring
 

Measures reported by UCSLanCloudPcEpTest

You can aggregate a number of uplink ethernet ports by configuring them as a port channel, so traffic will forward between your upstream LAN switch and Cisco UCS fabric interconnect over the aggregate port channel ports as a single aggregated link.

This test auto-discovers the Ethernet ports aggregated in each port channel on every Fabric Interconnect and reports the overall health, operational speed, and VLAN status of each Ethernet port. With the help of this test, problematic and slow ports can be identified.

The measures made by this test are as follows:

Measurement Description Measurement Unit Interpretation
Overall_status Indicates the current overall status of this port.   The values reported by this measure and their corresponding numeric values are described in the table below:

Measure Value Numeric Value
Unknown 0
Up 1
Down 2
Error-misconfigured 3

Note:

By default, this measure reports the above-mentioned Measure Values while indicating the overall status of a port. However, in the graph of this measure, port status will be represented using their numeric equivalents only.

The detailed diagnosis of this measure provides the complete details of a port, such as, the ID of the port, the slot ID, the Fabric Interconnect for which the port has been configured, the Type, the Port type, the flow control policy, the transport, and the port, locale, and name.

Admin_state Indicates the current administrative status of this port.   The values that this measure can report and the numeric values that correspond to the measure values have been detailed in the table below:

Measure Value Numeric Value
Enabled 1
Disabled 2

Note:

By default, this measure reports the above-mentioned Measure Values while indicating the administrative status of a port. However, in the graph of this measure, states will be represented using the corresponding numeric equivalents only.