The HpEvaProcTest tracks the CPU usage of and data traffic handled by each processor supported by the EVA storage array, and thus alerts administrators to any real or potential contention for CPU resources.

The parameters of this test are as follows:

• The TEST PERIOD list box helps the user to decide how often this test needs to be executed.

• In the HOST text box, the host name for which the test is to be configured has to be specified.

• The PORT text box refers to the port used by the EVA SAN device.The default port is 'null'.

• In the EVAPERFLOCATION text box, specify the full path of the directory in which the evaperf.exe has been installed.

• The SSSULOCATION test uses the EVAPerf software component to auto-discover the controllers on an EVA storage array. The EVA Controller Status test on the other hand uses the SSSU console to discover controller names. During auto-discovery, the EVAPerf utility reports the WWN names of the controllers. In contrast, the SSSU console reports the friendly names of the same controllers.
  To ensure that these controllers are represented using a uniform, consistent notation across the eG monitoring interface, you can optionally configure this test to use the SSSU console (instead of EVAPerf) to perform controller discovery. This way, the names of controllers will be the same for this test and the EVA Controller Status test. To enable controller discovery via the SSSU console, configure the full path to the location of the SSSU.exe in the SSSULOCATION text box. If you prefer not to use SSSU.exe for controller discovery and would rather use the EVAPerf component instead, then, set this parameter to none.

• In the USERNAME and PASSWORD text boxes, provide the user credentials that this test will use to access the target HP EVA SAN.

• Confirm the password by retyping it in the CONFIRM PASSWORD text box.

• Provide the name of the EVA SAN array that has been configured for monitoring in the ARRAYNAME text box.

• In the TIMEOUT text box, indicate the duration (in seconds) for which this test should wait for a response from the storage device. By default, this is set to 60 seconds.

• Finally, click the Update button.

When changing the configuration for specific servers, a “*” beside the text box corresponding to the parameter signifies that these values have to be manually configured by the user. The parameter values that require to be configured will typically be prefixed with a “$” or contain a series of “*”. A value of "none" in the parameter value indicates that the corresponding parameter value can be changed if required.