| Measurement |
Description |
Measurement
Unit |
Interpretation |
| Ups_status |
The current state of the UPS |
|
This measure reports the following states while indicating the current state of the UPS.
- Off
- Unknown
- OnLine
- On Battery
- On Smart Boost
- Timed Sleeping
- Software Bypass
- Rebooting
- Switched Bypass
- Hardware Failure Bypass
- Sleeping Until Power Return
- On Smart Trim
The numeric values that correspond to the above-mentioned states are as follows:
| Value |
State |
| 0 |
off |
| 1 |
Unknown |
| 3 |
onBattery |
| 4 |
onSmartBoost |
| 5 |
timedSleeping |
| 6 |
softwareByPass |
| 8 |
rebooting |
| 9 |
switchedBypass |
| 10 |
hardwareFailurebypass |
| 11 |
sleepingUntilpowerReturn |
| 12 |
onSmartTrim |
| 100 |
online |
Note:By default, this measure reports the above-mentioned states while indicating the current state of the UPS. However, the graph of this measure will be represented using the corresponding numeric equivalents of the states as mentioned in the table above.
|
| Input_voltage |
The current utility line voltage |
Volts
|
|
| Input_frequency |
The current input frequency to the UPS system |
Hz
|
|
| Output_voltage |
The current output voltage of the UPS system |
Volts
|
|
| Output_frequency |
The current output frequency of the UPS system |
Hz
|
|
| Output_load |
Indicates the current output load percentage of the UPS system. |
percent
|
|
| Output_current |
The current drawn by the load on the UPS |
Amps
|
This measure is directly proportional to the current output load percentage of the UPS.
|