| Measurement |
Description |
Measurement Unit |
Interpretation |
| battcpty |
Indicates the capacity remaining in the battery as a percentage of total capacity. |
Percentage |
Battery capacity goes down over time and any planning needs to he done on the basis of current capacity of the battery.
|
| battVolt |
Indicate the output voltage of the battery denoted in 1/10th of a Volt. |
Volts |
If the voltage is lower than expected, it may be a sign of poor battery performance which means the battery may need replacement sooner.
|
| battTemp |
Indicates the current internal temperature of UPS measured in 1/10th of a degree celcius. |
Celcius |
A high temperature may be a symptom of battery issue and can not just battery damage but also damage to internal wiring of the UPS.
|
| battRunTime |
Indicates the time it takes for the battery to go from current state to exhaustion. |
Seconds |
There should be enough time for you to make alternate arrangements if the battery is about to run out.
|
| battReplace |
Indicates if the batteries in the UPS needs replacement or not. |
|
The values reported by this measure and its numeric equivalent are mentioned in the table below:
| Measure Value |
Numeric Value |
| Battery needs replacing |
0 |
| Battery is fine |
1 |
Note:
By default, this measure reports the Measure Values listed in the table above to indicate the current status of this fan. The graph of this measure, however, represents the status of the fan using the numeric equivalents only.
|
| battChrg |
Indicates the charge remaining in the battery as a percentage of maximum charge it can hold. |
Percentage |
If the charge is less, you may need to plan replacing or charging the battery.
|