Measures reported by FPRSTSTest
This test auto-discovers the temperature sensors on the target Fujitsu Primergy Rack server and for each temperature sensor, this test reports the current status and the temperature. Using this test, administrators can easily figure out the temperature sensors that have failed and are about to fail. This way, administrators can replace the faulty temperature sensors before the hardware components fail. In addition, the temperature recorded by each temperature sensor too can be determined and sensors recording abnormal temperatures can be replaced.
Outputs of the test : One set of results for each Rack Unit: Temperature sensor available on the target Rack server being monitored.
The measures made by this test are as follows:
| Measurement |
Description |
Measurement Unit |
Interpretation |
| tsStatus |
Indicates the current state of this temperature sensor. |
|
The values reported by this measure and its numeric equivalents are mentioned in the table below:
| Measure Value |
Numeric Value |
| Normal temperature |
0 |
| Unknown |
1 |
| Not available |
2 |
| Ok |
3 |
| Sensor failed |
4 |
| Failed |
5 |
| Temperature warning toohot |
6 |
| Temperature critical toohot |
7 |
| Temperature warning |
9 |
Note:
By default, this measure reports the Measure Values listed in the table above to indicate the current state of each temperature sensor. The graph of this measure however is represented using the numeric equivalents only. |
| currentTemp |
Indicates the current temperature recorded by this temperature sensor. |
Celsius |
Ideally, the value of this measure should be low. A high value could be a cause for concern. |
|