eG Monitoring
 

Measures reported by CtxSDXXenVoltTest

If mission-critical hardware components of the SDX appliance - eg., CPU cores - experience severe and frequent voltage fluctuations, it can cause serious damage to the components. This in turn can render the SDX appliance unusable. To ensure the continuous availability and usage of the SDX appliance, administrators should keep an eye on the voltage of current passing through its core hardware components at all times, capture a voltage surge as soon as it occurs, and correct it immediately. This is can be achieved by periodically running the CtxSDXXenVoltTest test!

This test reports the voltage of each hardware component on the SDX appliance and also reveals the state of that component in terms of voltage. This way, the test brings sporadic spikes in voltage and its impact on hardware health to the immediate attention of administrators, thereby urging instant remedial action.

Outputs of the test : One set of results for each hardware component on the target NetScaler SDX.

Measurement Description Measurement Unit Interpretation
Status Indicates the current status of this hardware component, in terms of voltage.   The values that this measure can report and their corresponding numeric values have been listed in the table below:

Numeric Value Measure Value
100 Ok
0 Error

The value Error for this measure indicates that the current temperature value is out of range.

Note:

By default, this measure reports the above-mentioned Measure Values to indicate the current status of a hardware component. However, in the graph of this measure, the Measure Values will be represented using their corresponding numeric equivalents only.
Current_value Indicates the current voltage of this hardware component. Volts An unusually high or low value for this measure is a cause for concern as it could indicate a potential hardware failure.