| Measurement |
Description |
Measurement Unit |
Interpretation |
| Voltage_0 |
Indicates the voltage of the device connected to the health monitoring chip through pin 0. |
Volts |
Ideally, the value of this measure should be well within the range of the device that is connected to the health montoring chip. A sudden/consistent increase/decrease in this value could warrant an investigation. Observe the variations in the value of this measure over time and compare the values across pins to isolate the pin through which the device was connecting when it most often registered the maximum voltage. |
| Voltage_1 |
Indicates the voltage of the device connected to the health monitoring chip through pin 1. |
Volts |
| Voltage_2 |
Indicates the voltage of the device connected to the health monitoring chip through pin 2. |
Volts |
| Voltage_3 |
Indicates the voltage of the device connected to the health monitoring chip through pin 3. |
Volts |
| Voltage_4 |
Indicates the voltage of the device connected to the health monitoring chip through pin 4. |
Volts |
| Voltage_5 |
Indicates the voltage of the device connected to the health monitoring chip through pin 5. |
Volts |
| Voltage_6 |
Indicates the voltage of the device connected to the health monitoring chip through pin 6. |
Volts |
| Voltage_7 |
Indicates the voltage of the device connected to the health monitoring chip through pin 7. |
Volts |
| Fan_0_speed |
Indicates the speed of fan 0 if associated pin is connected to the health monitoring chip. |
Rpm |
Ideally, the speed of the fans must be within normal limits. High fan speed can very often be attributed to high temperatures. If a fan speed is found to be abnormal, then, you may want to check the Temperature measures reported by the test to figure out whether any device connecting to the health monitoring chip has recorded a very high temperature at around the same time. This way, you can also isolate the pin through which that device was connecting at the time of the problem. |
| Fan_1_speed |
Indicates the speed of fan 1 if associated pin is connected to the health monitoring chip. |
Rpm |
| Fan_2_speed |
Indicates the speed of fan 2 if associated pin is connected to the health monitoring chip. |
Rpm |
| Fan_3_speed |
Indicates the speed of fan 3 if associated pin is connected to the health monitoring chip. |
Rpm |
| Temperature_0 |
Indicates the temperature of the device that is connected to the health monitoring chip through pin 0. |
Celcius |
An abnormal temperature may cause damage to the device. So the temperature of the device must be well within normal limits. |
| Temperature_1 |
Indicates the temperature of the device that is connected to the health monitoring chip through pin 1. |
Celcius |
| Temperature_3 |
Indicates the temperature of the device that is connected to the health monitoring chip through pin 2. |
Celcius |
| Temperature_4 |
Indicates the temperature of the device that is connected to the health monitoring chip through pin 3. |
Celcius |