eG Monitoring
 

Measures reported by CpqRackBladeTest

This test auto-discovers the rack blades and reports the current status of each blade.

The measures made by this test are as follows:

Measurement Description Measurement Unit Interpretation
Rack_blade_status Indicates the current status of this rack blade.   The values that this measure can report and the numeric values they indicate are listed in the table below:
Numeric Value State
1 Other
2 Absent
3 Present

Note:

By default, this measure can report the States mentioned above while indicating the current status of this rack blade. However, the graph of this measure is indicated using the numeric equivalents.
Rack_blade_health_status Indicates the current health of this rack blade.   The values that this measure can report and the numeric values they indicate are listed in the table below:
Numeric Value State
1 Other
2 OK
3 Degraded
4 Failed

Note:

By default, this measure can report the States mentioned above while indicating the current health of this rack blade. However, the graph of this measure is indicated using the numeric equivalents.
Rack_blade_power_status Indicates the current power status of this rack blade.   The values that this measure can report and the numeric values they indicate are listed in the table below:
Numeric Value State
1 Other
2 On
3 Off
4 Power staged off

Note:

By default, this measure can report the States mentioned above while indicating the current power status of this rack blade. However, the graph of this measure is indicated using the numeric equivalents.
Rack_blade_led_status Indicates the current LED status of this rack blade.   The values that this measure can report and the numeric values they indicate are listed in the table below:
Numeric Value State
1 Other
2 None
3 LED On
4 LED Off

Note:

By default, this measure can report the States mentioned above while indicating the current LED status of this rack blade. However, the graph of this measure is indicated using the numeric equivalents.
  This test is disabled by default. To enable the test, go to the enable / disable tests page using the menu sequence : Agents -> Tests -> Enable/Disable, pick the desired Component type, set Performance as the Test type, choose the test from the disabled tests list, and click on the >> button to move the test to the ENABLED TESTS list. Finally, click the Update button.