Agents Administration - Tests
 

Configuration of RabMQClusterTest

Using this test, you can keep tabs on garbage collection activity on each node of a cluster and identify the node from which the least memory was reclaimed. When a cluster under-performs, you can use this test to figure out if the dip in cluster performance is owing to excessive heap growth on a node caused by inefficient garbage collection.

The default parameters associated with this test are as follows:

  • The TEST PERIOD list box helps the user to decide how often this test needs to be executed.

  • In the HOST text box, specify the host for which the test is to be configured.

  • In the PORT text box, specify the port at which the configured Host listens; by default, this is 15672.

  • The eG agent connects to the Management Interface of the rabbitmq-management plugin of the target node, and runs HTTP-based API commands on the node using the plugin to pull metrics of interest. To connect to the plugin and run the API commands, the eG agent requires the privileges of a user on the cluster who has been assigned the ‘monitoring’ tag. If such a user pre-exists, then configure this test with the USERNAME and PASSWORD of that user. On the other hand, if no such user exists, then you will have to create a user for this purpose using the Management Interface. The steps for this have been detailed in Monitoring RabbitMQ Cluster document. In this case, make sure you configure this test with the USERNAME and PASSWORD of the new user. Finally, confirm the password by retyping it in the CONFIRM PASSWORD text box.

  • By default, the SSL flag is set to No, as the target node is not SSL-enabled by default. If the node is SSL-enabled, then set this flag to Yes.

  • If multiple components of the same component type are awaiting configuration, then an APPLY TO OTHER COMPONENTS check box will appear in this page. Clicking on this check box will allow you to apply the configuration to all/selected components of that type.

  • Once the necessary values have been provided, clicking on the UPDATE button will register the changes made.

When changing the configuration for specific servers, a “*” beside the text box corresponding to the parameter signifies that these values have to be manually configured by the user. The parameter values that require to be configured will typically be prefixed with a “$” or contain a series of “*”. A value of “none” in the parameter value indicates that the corresponding parameter value can be changed if required.